Immersion tank flange heater
Description
Suitable for heating of fluids both liquids and gases and also
solids. The heater consists of a certified flameproof enclosure
D-8680, containing:
- certified electric heating elements (Ex e II) tubular, ceramic or
cartridge heating elements.
- one manually protective thermostat with manual reset or
one thermocouple or pt100 as a safety device. Thermocouple
and pt100 are only applicable in combination with a
temperature controller installed in a control panel.
- one control thermostat for fluid temperature. Alternatively,
one thermocouple or pt100.
- threaded holes for cable entries and/or plugs of a certified
flameproof model Ex d II B or Ex d II C.
The flame-proof enclosure has been built up out of a
seamless body, a top cover and base plate. Each cover and
base plate has been provided with 6 screw thread windings
with a total length of 18 mm. The connection length of the
threaded joint between cover or base plate and body should
always be 5 thread windings minimum. The cover has been
locked with an M4 screw and the base plate with an M6 screw.
In the base plate of the enclosure spacer tubes can be welded
in which the heating elements are brazed or welded.
Applications:
2.CSA Listed Explosion Proof/Hazardous Area Heaters
3.All Oil Grades
4.Equipment for Food Processing
5.Heat Transfer Systems
6.Cleaning/Rinsing Tanks
7.Equipment for Process Air
10.Application for Petro Chemical
12.Water/Recycling and Sewage Processing Application
13. Purification & Caustic Solutions
Standard Flanged Immersion Heaters-Construction Features:
Elements Materials - Copper, Steel, 304/316 Stainless Steel, Incoloy
Number of Elements in Flanges - 3, 6, 9, 12, 18, 21, 27, 36, 45 plus
Element Diameter - 0.315" – 0.430"
Watt Density - 6.5, 15, 23, 45, 75W/in2
Flange - Materials - Carbon Steel, Stainless Steel,
Flange Rating - 150 lb. Pressure Class per ANSI B16.5
Flange Sizes - 3", 5", 6", 8" 10", 12", 14", 150 lb.
Our Flanged Immersion Heaters offer Highly Conductive Tubular Heating Elements - custom flanged immersion heater elements use the purest blends of magnesium oxide (MgO) powder. In addition this refractory is compacted to a rock hard like density. This is important because it ensures (i) maximum thermal conduction and (ii) maximum electrical resistance, promoting long coil/resistance wire life.
BRIGHT Company Flanged Immersion Heaters offer Heavy Coil Construction - Heating coils are designed for low watt density operation. This is accomplished by increasing the coil diameter and length and thereby increasing the surface area of the coil, limiting the surface temperature of the resitance wire yielding longer coil and therfore heater life.
